Block stripped of everything.
the core plugs were rotten
An English HillClimb rebuild.
-
so onto the reason i started this engine strip. i was thinking that something was not quite right.
opps -
so more stripping down and cleaning
cleaned up the alloy fly wheel and steel back plate along with the old grey spring and "standard" friction plate.
spare center if needed -
stripped down the head.
it needs new valves and guides as a minimum
-
not very nice,
the bearings…..
Cheers
Rüdiger
-
ok the engine situation is in limbo as i have found a nice ***** in between two of the valves so if anyone knows someone who can fix this please let me know
so lets make a jig to get the steering wheel in about the right place.
now making up supports to be welded in place. -
Hi Nick,
maybe something like this is helpful?
https://www.reichle.de/dienstl…-mittels-laserschweissen/
Looking for laser welding company?! -
In Hechtsheim the is a weldingschool, well known in some article in "Oldtimerpraxis". The chiefs do some work for customers too.
René
-
thanks to both. lets see what happens,
Rene any more info?this afternoons job
will finish off the welding when it is off the trailer -
Personally I wouldn't like to sit in a shoe box doing 100mph while two extreme rigid barrels are pointing at my chest.
-
I look around and around in the "www", but I couldn't find it.
It was a public school for "Auszubildende im Metallhandwerk", I booked a day there learning welding about ten years ago. You lnow where "Jaguar" in Hechtsheim is? When I remember right, it was one street later, entering the Industriepark to Jaguar, if you see it turm right untill the next crossing. Turn left, it's than on the right side.
Ask there if they do something welding, in the past they do it. But think about "Corona", it's a public buisiness, may be they're closed.
René
-
Personally I wouldn't like to sit in a shoe box doing 100mph while two extreme rigid barrels are pointing at my chest.
much safer than the standard car. dont forget i am strapped in and will not be moving. while the standard car has a long shaft firmly connected to the rack pointing straight at your chest.
but thanks for your concern.
-
Finish till Miniholiker? Think this will be the first Meeting after Corona..
-
Finish till Miniholiker? Think this will be the first Meeting after Corona..
i hope so if i dont run out of Money
-
next job is plumbing in the fire suppression system.
-
i hope so if i dont run out of Money
naaaaaaa! you can use a cheap 998 every time... -
box together just waiting on a few bits to finish it off.
the pinion support housing points to note.
the bottom right mounting to the support has a different thread than the original so needs a replacement stud/bolt original casting was UNC and the support is UNF
also will not work with a lower steady.
also bought some more spanners
-
made a start on the new braking set up.
Jetzt mitmachen!
Du hast noch kein Benutzerkonto auf unserer Seite? Registriere dich kostenlos und nimm an unserer Community teil!